Is the nylon cable tie mold affected by temperature?
Many molds are affected by temperature, and nylon cable ties are no exception. Nylon cable splicing mold is a good helper for making molds. The temperature requirements of this kind of mold equipment are also some of the following.
1 Nylon cable ties are hygroscopic. Do not open the package before use. After opening the package in a wet environment, try to use up within 12 hours, or repack the unused nylon cable ties so as not to affect the nylon ties during handling. The tensile strength and rigidity of the belt. 2 manipulation
When using, use the tension to pull the tensile strength (tension) of the nylon cable tie itself. 3 The diameter of the bundled object is smaller than the diameter of the nylon cable ties. The remaining length of the belt is preferably 80mm. Nylon cable ties maintain excellent mechanical properties over a wide temperature range (-40 to 120 ° C)
Characteristics and heat aging resistance
Humidity affects nylon cable ties Nylon cable ties maintain excellent mechanical properties in a humid environment. Nylon sheets are hygroscopic, have increased moisture (water content), have higher elongation and impact strength, but have tensile strength and The rigidity gradually decreases. Electrical characteristics and flame retardancy
Long cable ties have good edge, electrical rated temperature less than 105 degrees does not affect its performance, flame retardancy reaches UL measurement 94V-2. The plastics industry is worthy of vigorous development, and the prospects are very optimistic. It is understood that the high growth of the plastics industry is still unabated, and it is still in a period of rapid development. And electricity
Sub-communications, automobiles, building materials, office equipment, and daily necessities are still driving the rapid development of plastics. It is expected that the annual consumption of plastics will increase by 18%. The plastics industry is a sunrise industry worthy of vigorous development, and it is also an industry with a promising market prospect. Therefore, it needs to be built
Establish an e-commerce platform with a system of admission to regulate the quality of market products, and then drive the upgrade and transformation of the entire plastics industry. Access is the standard, which is the threshold for entering the market. It is to combine the direct and indirect experience of plastic processing enterprises to establish their own standard system.
A technical support platform for upgrading plastic products.